1. Poulan 733 864 Parts Manual
2. 733-864 Poulan Parts

Need to fix your HD145H42J 14.5 HP 42 Inch Lawn Tractor? We have parts, diagrams, accessories and repair advice to make your tool repairs easy.

. OWNER'S MANUAL MODEL NO. PC14542D 14.5 HP 42 Inch Lawn Tractor For Parts and Service, contact our authorized distributor: call 1-800-849-1297 For Technical Assistance: call 1-800-829-5886 179414 4.20.01 JH PRINTED IN U.S.A. Safe Operation Practices for Ride-On Mowers IMPORTANT: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROWING OBJECTS.

Cushman Turf-Truckster Gas. Parts & Maintenance Manual, 898627, 898628, 898671, 898673, 898695, 4120402 Parts & Maintenance Manual, 84043,. Models: Haulster. Service & Repair Manual. Costs will vary depending on a variety of factors which include the size and weight of the item as well as the.

FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. GENERAL OPERATION. Read, understand, and follow all instructions in the manual and on the machine before starting.

Safe Operation Practices for Ride-On Mowers. Be sure the area is clear of other people before mowing.

Stop machine if anyone enters the area. Never carry passengers or children even with the blades off. Do not mow in reverse unless absolutely necessary. Al- ways look down and behind before and while backing.

PRODUCT SPECIFICATIONS GASOLINE CAPACITY 1.25 GALLONS AND TYPE: UNLEADED REGULAR OIL TYPE (API-SF-SJ): SAE 30 (above 32°F) SAE 5W-30 (below 32°F) OIL CAPACITY: 3 PINTS SPARK PLUG: CHAMPION RC12YC (GAP:.030') GROUND SPEED (MPH): FORWARD: REVERSE: TIRE PRESSURE: FRONT: REAR: CHARGING SYSTEM: 3 AMPS BATTERY 5 AMPS HEADLIGHTS. UNASSEMBLED PARTS Steering Wheel Steering Extension Shaft Steering (1) Lockwasher 3/8 Boot (1) Large Flat Washer (1) Hex Bolt 5/16-18 x 1-1/4 Steering Wheel Adapter (1) Washer 17/32 x 1-3/16 x 12 Gauge Steering Wheel Insert (1) Locknut 5/16-18 (1) Hex Bolt 3/8-16 x 1 Seat (1) Lock. Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness. HOW TO SET UP YOUR TRACTOR CHECK BATTERY (See Fig. 2).

Lift seat pan to raised position and open battery box door. If this battery is put into service after month and year indicated on label (label located between terminals) charge battery for minimum of one hour at 6-10 amps. TO DRIVE TRACTOR OFF SKID (See Opera- tion section, page 10, for location and func- tion of controls) WARNING: Before starting, read, understand and follow all instructions in the Operation section of this manual. Be sure tractor is in a well-ventilated area. Be sure the area in front of tractor is clear of other people and objects.

These symbols may appear on your tractor or in literature supplied with the product. Learn and understand their meaning.

BATTERY CAUTION OR WARNING ENGINE ON ENGINE OFF FUEL CHOKE ATTACHMENT REVERSE CLUTCH ENGAGED ATTACHMENT CLUTCH DISENGAGED IGNITION DANGER, KEEP HANDS AND FEET AWAY OPERATION REVERSE FORWARD. KNOW YOUR TRACTOR READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR Compare the illustrations with your tractor to familiarize yourself with the locations of various controls and adjustments. Save this manual for future reference. AMMETER THROTTLE/CHOKE CONTROL CLUTCH/BRAKE PEDAL Our tractors conform to the safety standards of the American National Standards Institute. The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye damage. Always wear safety glasses or eye shields while operating your tractor or performing any adjustments or repairs. We recommend a wide vision safety mask over spectacles or standard safety glasses.

TO ADJUST GAUGE WHEELS (See Fig. 6) Gauge wheels are properly adjusted when they are slightly off the ground when mower is at the desired cutting height in operating position. Gauge wheels then keep the deck in proper position to help prevent scalping in most terrain conditions. ADD GASOLINE.

Fill fuel tank. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. (Use of leaded gasoline will increase carbon and lead oxide deposits and reduce valve life). Do not mix oil with gasoline. Purchase fuel in quantities that can be used within 30 days to assure fuel freshness.

CUSTOMER RESPONSIBILITIES MAINTENANCE SCHEDULE FILL IN DATES AS YOU COMPLETE REGULAR SERVICE Check Brake Operation Check Tire Pressure Check Operator Presence and Interlock Systems Check for Loose Fasteners Sharpen/Replace Mower Blades Lubrication Chart Check Battery Level Clean Battery and Terminals Check Transaxle Cooling Adjust Blade Belt(s) Tension Adjust Motion Drive Belt(s) Tension. CUSTOMER RESPONSIBILITIES TRACTOR Always observe safety rules when performing any mainte- nance. BRAKE OPERATION If tractor requires more than six (6) feet stopping distance at high speed in highest gear, then brake must be adjusted. (See “TO ADJUST BRAKE” in the Service and Adjustments section of this manual). CUSTOMER RESPONSIBILITIES BATTERY Your tractor has a battery charging system which is suffi- cient for normal use. However, periodic charging of the battery with an automotive charger will extend its life.

Keep battery and terminals clean. Keep battery bolts tight. CUSTOMER RESPONSIBILITIES CLEAN AIR SCREEN Air screen must be kept free of dirt and chaff to prevent engine damage from overheating. Clean with a wire brush or compressed air to remove dirt and stubborn dried gum fibers.

ENGINE COOLING FINS (See Fig. 13) Remove any dust, dirt or oil from engine cooling fins to prevent engine damage from overheating.

CUSTOMER RESPONSIBILITIES MUFFLER Inspect and replace corroded muffler and spark arrester (if equipped) as it could create a fire hazard and/or damage. SPARK PLUGS Replace spark plugs at the beginning of each mowing season or after every 100 hours of operation, whichever occurs first.

SERVICE AND ADJUSTMENTS CAUTION: BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:. Depress clutch/brake pedal fully and set parking brake. Place gearshift lever in neutral (N) position. Place attachment clutch in “DISENGAGED” position. Turn ignition key “OFF” and remove key.

SERVICE AND ADJUSTMENTS TO LEVEL MOWER HOUSING Adjust the mower while tractor is parked on level ground or driveway. Make sure tires are properly inflated (See “PROD- UCT SPECIFICATIONS” section of this manual). If tires are over or underinflated, you will not properly adjust your mower. SERVICE AND ADJUSTMENTS TO ADJUST BRAKE (See Fig.

22) Your tractor is equipped with an adjustable brake system which is mounted on the right side of the transaxle. If tractor requires more than six (6) feet stopping distance at high speed in highest gear on a level dry concrete or paved surface, then brake must be adjusted. SERVICE AND ADJUSTMENTS TO REMOVE WHEEL FOR REPAIRS (See Fig.

25). Block up axle securely. Remove axle cover, retaining ring and washers to allow wheel removal (rear wheel contains a square key - Do not lose). Repair tire and reassemble. SERVICE AND ADJUSTMENTS KEPS POSITIVE (RED) CABLE FIG. 28 TO REPLACE HEADLIGHT BULB. Raise hood.

Pull bulb holder out of the hole in the backside of the grill. Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill. Immediately prepare your tractor for storage at the end of the season or if the tractor will not be used for 30 days or more. CAUTION: Never store the tractor with gasoline in the tank inside a building where fumes may reach an open flame or spark. TROUBLESHOOTING POINTS PROBLEM CAUSE Will not start Out of fuel. Engine not “CHOKED” properly.

Engine flooded. Bad spark plug. Dirty air filter. Dirty fuel filter. Water in fuel.

Loose or damaged wiring. Carburetor out of adjustment. Engine valves out of adjustment. Hard to start Dirty air filter. TROUBLESHOOTING POINTS PROBLEM CAUSE Engine continues to run Faulty operator-safety presence control system. When operator leaves seat with attachment clutch engaged Poor cut - uneven Worn, bent or loose blade. Mower deck not level.

Buildup of grass, leaves, and trash under mower. Bent blade mandrel. REPAIR PARTS TRACTOR -MODEL NUMBER PC14542D SCHEMATIC AMMETER (OPTIONAL) IGNITION SWITCH IGNITION SWITCH POSITION CIRCUIT “MAKE” M+G+A1 NONE RUN/LIGHT B+A1 A2+L B+A1 NONE START B + S + A1 NONE BATTERY FUSE WHITE CLUTCH / BRAKE (PEDAL UP) WHITE BLACK BLACK. REPAIR PARTS TRACTOR -MODEL NUMBER PC14542D ELECTRICAL D.C. REPAIR PARTS TRACTOR -MODEL NUMBER PC14542D ELECTRICAL NOTE: All component dimensions give in U.S. Inches PART DESCRIPTION 144925 Battery 12 Volt 25 Amp 74760412 Bolt Hex Hd 1/4-20unc X 3/4 156417 Case Battery 153664 Switch Interlock Push -In 166181 Harness Asm Light W/4152J 4152J.

REPAIR PARTS TRACTOR -MODEL NUMBER PC14542D CHASSIS AND ENCLOSURES. REPAIR PARTS TRACTOR -MODEL NUMBER PC14542D CHASSIS AND ENCLOSURES PART DESCRIPTION 174620 Chassis 176554 Drawbar 17060612 Screw 3/8-16 x 3/4 155272 Bumper Hood/Dash 155923 Saddle Flat Lt 155138 Clip Retainer Slide-On 168348X012 Dash 72140608 Bolt RdHd Sqnk.

3/8-16 Unc x 1 155927 Panel Asm. REPAIR PARTS TRACTOR -MODEL NUMBER PC14542D DRIVE. REPAIR PARTS TRACTOR -MODEL NUMBER PC14542D DRIVE PART DESCRIPTION -Transaxle (Ordre parts from transaxle manufacturer) Peerless 206-545C 146682 Spring Return Brake T/a Zinc 123666X Pulley Transaxle 18' tires 12000028 Ring Retainer # 5120X Strap Torque 30 Degrees. REPAIR PARTS TRACTOR -MODEL NUMBER PC14542D STEERING ASSEMBLY.

Poulan 733 864 Parts Manual

REPAIR PARTS TRACTOR -MODEL NUMBER PC14542D STEERING ASSEMBLY NOTE: All component dimensions given in U.S. Inches PART DESCRIPTION 140044X428 Wheel Steering Auto Black 154427 Axle Asm Front 169840 Spindle Asm Lh 169839 Spindle Asm Rh 6266H Bearing Race Thrust Harden 121748X Washer 25/32 X 1 5/8 X 16ga 19272016. REPAIR PARTS TRACTOR -MODEL NUMBER PC14542D ENGINE OPTIONAL EQUIPMENT Spark Arrester. REPAIR PARTS TRACTOR -MODEL NUMBER PC14542D ENGINE PART DESCRIPTION 170551 Control Throt /Ch 23.5 Lh Flag 17720410 Screw Hex Thd Cut 1/4-20x5/8 T -Engine Briggs Model 287707 (Order Parts From Engine Manufacturer) 137352 Muffler Exhaust B&S Lt 165291.

REPAIR PARTS TRACTOR -MODEL NUMBER PC14542D SEAT ASSEMBLY PART DESCRIPTION 140116 Seat 140551 Bracket Pnt Pivot Seat (blk ) 71110616 Bolt 19131610 Washer 13/32 x 1 x 10 Ga 145006 Clip Push-In Hinged 73881X Spring Seat Cprsn 2 250 Blk Zi 17000616 Screw 3/8-16 x 1.5 19131614. Decal Fender 160396 Decal V-belt Schematic 42' 145005 Decal Battery Danger/Poison 176396 Decal HP Engine 133671 Pad Footrest 138311 Decal Lift Handle 179414 Manual Owner’s English 179415 Manual Owner’s French PART DESCRIPTION 59192 Cap Valve Tire 65139 Stem Valve 106222X. REPAIR PARTS TRACTOR -MODEL NUMBER PC14542D MOWER LIFT 17 18 20.

REPAIR PARTS TRACTOR -MODEL NUMBER PC14542D MOWER LIFT PART DESCRIPTION 159460 Wire Asm Inner/Sprg w/Plunger 159471 Shaft Asm Lift 105767X Pin Groove 12000002 E Ring #511621 Washer 21/32 x 1 x 21 Ga. 120183X Bearing Nylon 109413X Grip Handle 124526X Button Plunger. REPAIR PARTS TRACTOR -MODEL NUMBER PC14542D MOWER DECK 153 154. REPAIR PARTS TRACTOR -MODEL NUMBER PC14542D MOWER DECK PART DESCRIPTION 165892 Mower Deck Assembly, 42' 72140506 Bolt 138017 Bracket Asm Fr. Sway Bar 3/42 165460 Bracket Asm Deck 42' Sway Bar 4939M Retainer Spring 130832 Arm, Suspension, Rear 850857 Bolt 3/8-24 x 25 Grade 8 patched 10030600. SERVICE NOTES. The Manufacturer warrants to the original consumer purchaser that this product as manufactured is free from defects in materials and workmanship.

For a period of two (2) years from date of purchase by the original consumer purchaser, we will repair or replace, at our option, without charge for parts or labor incurred in replacing parts, any part which we find to be defective due to materials or workmanship.

We bought a Poulan riding lawn mower off craigslist. Model # 733-864 We were told that it just made a clicking sound when turned left. We have never owned a riding mower. Dh was able to get it to turn on and the motor sounds good.

However at one point of trying to get it to drive he turned it off before disengaging the blades. Now it is engaged and will not turn on. How do we disengage the blad to get the mower to turn on again? After we get the mower to turn on again how do we get it to actually drive? I'm not sure what model that is, as Google does not return any results.

733-864 Poulan Parts

Because of that, it's going to make it very hard to figure how this mower is configured. If it has a switch for the blades/PTO, make sure it's in the off position. If it just has a lever for the deck, make sure it's all the way up. Also be sure your foot is on the brake. As for driving it, it's also hard to help you with that as I can't tell from what you've said it has a manual (shift on the go) transmission or a hydrostatic.